rb2011UiAS-2HnD Weak Wireless Signal Problem

[nacer]

@Quindor

Could you set frequency mode to “regulatory-domain” and Country to your country. And on the HT tab, select all chains as TX and RX and on the TX Power tab to default and see what your signal is?

Did you upgrade your routerboard firmware while upgrading to RouterOS 6.12?

If that doesn’t work, maybe you could open the box (a few screws and a hinge) to check if the antenna connectors are properly connected? Maybe try disconnecting and reconnecting them to be sure? Be carefully not to bend the cables to tightly while doing so.

Hopefully that fixes your problem, if not, you probably do have a hardware issue.

Hi,

In wireless section of forum, MikroTik Support guy advised me to set the region US for the best performance. But either with regulatory-domain or other settings, nothing worked http://forum.mikrotik.com/t/bad-wireless-reception-with-rb2011uas-2hnd-in/62979/1

I opened the device last night. Nothing seemed wrong. Connectors seems little bit loose but I am not sure how it was supposed to be.
I pushed them gently to fix just in case. But they are not close fit like pcmci type wireless cards antenna connectors.
( And of course router was unplugged. @jarda )

Device has ROS 6.12. And I checked and try almost everything include HT settings. BG mode only 20 Mhz , Fix TX 30 Dbm etc..

In HT settings nothing changes any result.