Hi everyone. I’m new to MikroTik. I had help setting up my gear (CCR2004-16G-2S+PC router, CRS326-24G-2S+RM switch, and two cAP ax access points). Everything appears to be working, but the cAPs are not broadcasting their SSIDs. The person who helped me with the setup also can’t figure it out. Below …

Hard to tell from those screenshots ... (I was thinking to remove them but decided to let them be) I assume you are using both devices in cap mode ? Then we need config (at least from wifi part) from capsman controller and config from 1 cap device (assuming the other one is configured the same). /…

[image] Forum rules Beginner Basics If you are new here - welcome! For your first question, please provide a clear description of your setup, make sure you are running the latest RouterOS version and include the configuration output. You can censor out password…

Most likely, the WIFI package isn't installed on the access points. Go to the “System” tab and check the “Packages” section. Also, update all devices to at least version 7.21.4 at the same time.

[image] Ca6ko: Most likely, the WIFI package isn't installed on the access points. Go to the “System” tab and check the “Packages” section. From the screenshot, caps are at 7.18.2 and that should be factory version then. So while still possible, I would be highly surprised if wifi package wa…

I don't know of any other reason why all Wi-Fi interfaces are missing on the CAP ax.

I suggest to take a look at [WiFi -> WiFi -> Configuration -> CAPsMAN] and [WiFi -> WiFi -> Configuration -> CAP] on the CAPsMAN and the CAP respectively. These are found over to the right of the window. Check that CAPsMAN or CAP are enabled as appropriate.

[image] salzer: The person who helped me with the setup also can’t figure it out. Artificial Deficiency is not a person.

SSIDs not broadcasting. Any advice?

Hardware MikroTik hardware general

BartoszP June 29, 2026, 2:04pm 3