switch all ports not sticking/setting for RB3011

Hardware MikroTik hardware general
1

Using 6.39.1 software on RouterBOARD 3011UiAS (https://routerboard.com/RB3011UiAS-RM)

I am having trouble setting switch-all-ports

[admin@Garage Router] /system identity> /interface ethernet switch       
[admin@Garage Router] /interface ethernet switch> set switch1 switch-all-ports=yes 
[admin@Garage Router] /interface ethernet switch> print
Flags: I - invalid 
 #   NAME                                          TYPE             MIRROR-SOURCE                                        MIRROR-TARGET                                        SWITCH-ALL-PORTS
 0   switch1                                       QCA-8337         none                                                 none                                                
 1   switch2                                       QCA-8337         none                                                 none

No matter what I set, it’s not applied.

No error is presented.

Any ideas?

2

Because it isn’t implemented on that router. All ports always go to the switch chip.

Sent from my Pixel XL using Tapatalk

3

For switching ports 1-5 can switch and 6-10 can but you cannot cross between the chips.
You can master-slave the ports as above then add them to a bridge to get traffic crossing between all ports.

If you needed a switch you’d have been better with a CRS series.