why ???serial0 flow-control=hardware ????

RouterOS General
1

/port print t

0 name=serial0 … flow-control=hardware

Why don’t setup flow-control=none

this is easy!!!

if i use serial control use set serial0 flow-control=none
but if system error ,i use system reset ,this flow-control=hardware .

I system is not display monitor .

hope mikrotik change setup

default flow-control=none

thanks.

Router freezes when booting with RS232 Modem attached
2

I agree, flow-control=none is default on most platforms.

3

Very hope Mikrotik setup default flow-control=none

Very thanks.