Hi All, Apologies as I am new to Mikrotik. I am trying to solve a scenario where I am required to contain an entire segment of a network into a single VRF including the WireGuard interface/operations. I am not having any luck. Here is the breakdown - All interfaces associated with this segment o…

this is from divB /interface/wireguard/set wg-bg1-wwan vrf=wwan /interface/wireguard/set wg-bg2-wwan vrf=wwan makes lot of sense

Rule #12 seemingly applies, JFYI: [image] The twelve Rules of Mikrotik Club Beginner Basics Preamble and disclaimer: The following is a set of Rules that are intended as advice useful to avoid the most common errors observed in configuration posted on this for…

Your incomplete configuration except hat a lot of nonsenses: VLAN ID 1303 is tagged for bridge1 (and ether2) but there is no VLAN interface defined to make use of it. You have a VLAN interface defined for VLAN ID 100, but that VLAN ID is associated with no ports. You appear to use only IPv4…

[image] CGGXANNX: What is this??? A very small portion of the internet? :wink: https://www.calculator.net/ip-subnet-calculator.html?cclass=any&csubnet=24&cip=0.0.0.0&ctype=ipv4&x=Calculate

*) wireguard - added VRF option (CLI only) (additional fixes); does anyone tested that? i did try, no luck

Worked for me. I only did a quick test, so there may be things lurking in the shadows.

thanks lurker888 . am i doinf right? [wg1]

[image] nichky: am i doinf right? No, the vrf property of the WireGuard interface is not made for what you intend to have in your configuration above. You should clear its current value. You set that property if you want the outer UDP packets, that transport the encrypted tunnel, to be sent …

i think i understood what u are saying. You set that property if you want the outer UDP packets, that transport the encrypted tunnel, to be sent and received in a particular VRF. Are u willing to give me just basic e.g. so i can play around

Thank you for your reply. I changed the original output to make it less convoluted but ended up just making it worse. I’ve updated the original post.

Thanks for trying it out. I will try it on another device and see if I have the same issue.

Wireguard VRF Issues

RouterOS General

jaclaz November 18, 2025, 10:22pm 2

Rule #12 seemingly applies, JFYI: