2 WAN, policy routing to use specific WAN at each subnet (1 native subnet and 1 VLAN subnet)

[jaclaz]

Regarding scope and target-scope, a good explanation by CGGXANNX and the simplified way are on this thread:

Primary gateway with static ip address not activating

Hi all, I have a 2 gateway setup. I have my primary gateway on ether1 and a secondary gateway on ether2. The primary gateway on ether1 has a static IP address. The router is connected to the ISP’s DSL modem router. This connection is working. However, I am unable to connect by this gateway. I cannot see any error in the logs at least in the way they are currently configured. I had the ISP check their connection and it is working. The secondary gateway however is working. This gateway has an I…

starting here, JFYI:

Primary gateway with static ip address not activating

Strictly speaking you can “set scope to 10 and forget” because in the background RouterOS silently increases the scope value of the route to become at least 1 more than the scope of the gateway IP Routing - RouterOS - MikroTik Documentation So, if we want to be explicit, your example routes should be like this: add dst-address=0.0.0.0/0 gateway=8.8.8.8 distance=1 scope=> 12 > target-scope=> 11 > check-gateway=ping comment=“Primary default route” add dst-address=8.8.8.8/32 gateway=122.1…