menego
You can do only one fast 2CA with B3+B7 OR B20+B1/3/7 who is poor CA.
In future that merge/aggregate/sum speed of 2CA willbe more correct then now.
First: If I use cell lock function seems that after a variable amount of time I can’t have internet. I can’t understand if the LTE modem can’t connect or is stuck.
True, and this is still problem. We must use a own watdog to check that.
Simple watchdog: http://forum.mikrotik.com/t/sxt-lte-4g-cat6/134468/1
Advance watchdog: http://forum.mikrotik.com/t/tx-rx-fp-rx-dropped-pppoe-account/132656/1
Simply in cellular tab I didn’t find any connection.
I need to remove cell lock with /interface lte at-chat lte1 input=“AT*Cell=0”
True, I remember that fw v20..23 have that behaviour. v24 have works best. Just sending the at*cell=2,3,… means set the same celllock do re-connection and ca-band still works. But still have problem with that cellLock stuck.
Second: Always after a variable amount (hours, days..) of time my modem disconnect from the cell that is near home and connect to a more distant cell that have poor performance and bad signal.
I can’t reconnect again in short time.
This I can’t figure if is my problem or if is the cell that ban me.
In this case I tried to connect to other bands in the cell but is impossible.
I not know that problem. I can always connect to the cell who works me in default connection.
Cell who was disconnect via cell-monitor can but not must work. This can not work but of you connect at specific CellID then it’s should work.
Any log that I can collect and check ?
Watch LTE parameters: http://forum.mikrotik.com/t/sxt-lte-4g-cat6/134468/1