RouterOS version 7.1rc2 has been released in public “development” channel!
What’s new in 7.1rc2 (2021-Aug-31 11:07):
*) added “failure” flag for VRRP;
*) fixed support for IGMP-Proxy;
*) fixed support for NV2;
*) fixed wifwave2 virtual AP configuration on boards with country locks;
*) improved routing filter configuration;
*) improved system stability when using CAKE and fq_codel queues;
*) other minor fixes and improvements;
Thanks for your efforts, will give it a try, particularly for testing cake stability. Hoping GRE tunnel throughput might also be a bit faster but I understand that might be a while before that is hopefully looked into and sorted. Issue seems to be that it’s only using a single thread, unlike my former Edgerouter which used multithreading for the GRE tunnel and maxed the CPU cores, have already recently reported this bug/issue though.
Haha, used “System/Packages/Check For Upgrade” to update from some unofficial support-provided 7.1.RC2 to official 7.1RC2. Now my device is a brick. Did not come up again. Needs netinstall I guess. Well played!
edit:
Could connect with Winbox in MAC-mode. Device has apparently reset itself WITHOUT default-config. Or at least in some weird state without IP-address and non-working WIFI (though enabled with default as far I can see). I am always wondering HOW that can be even happen.
Easy! The config is corrupt and is cleared on reboot. It would probably have happend when you had only rebooted. It is still happening in some cases in v7.
When you want to be sure, reboot before trying to update. Then you know if it is caused by the previous version or by the updating.
On smips, the same. With netinstall, no previous config.
MMM MMM KKK TTTTTTTTTTT KKK
MMMM MMMM KKK TTTTTTTTTTT KKK
MMM MMMM MMM III KKK KKK RRRRRR OOOOOO TTT III KKK KKK
MMM MM MMM III KKKKK RRR RRR OOO OOO TTT III KKKKK
MMM MMM III KKK KKK RRRRRR OOO OOO TTT III KKK KKK
MMM MMM III KKK KKK RRR RRR OOOOOO TTT III KKK KKK
MikroTik RouterOS 7.1rc2 (c) 1999-2021 https://www.mikrotik.com/
Do you want to see the software license? [Y/n]: n
Press F1 for help
[admin@MikroTik] > /routing/bgp/
connection session template vpn export
[admin@MikroTik] > /routing/bgp/advertisments
bad command name advertisments (line 1 column 14)
[admin@MikroTik] >
i like to ask, is there any chance to solve issue/problem with “hidden” ipv6 address/route ?
here i mean, IPV6 → Settings → Accept router advertisements → YES
it is sooooo confusing, that there is no v6 address and no v6 route listed
so, when you are in hurry, and things are working very strange, it is time consuming to hunt down “why the hell this router could do v6, and other no” … then you realize that someone turned on SLAAC
and then start coursing, and wondering, how could it be? routing equipment without routing info …
so, any chance to UNhide these v6 info ?
( did i asked politely this time? )
